apps.AppDB

Master Bender is a pipe bending calculator for electricians. Master Bender can also be used by plumbers and pipe fitters, who can enter their own tools into program.

Master Bender aids you in bending conduit raceways. It takes the math out of bending and allows you to concentrate on the task at hand.

Master Bender uses a more precise conduit bending algorithm than the cosecant method that is commonly used in the industry. This gives you more accurate bends with less waste.

Master Bender supports the following types of bends:

* offset bends and rolling offset bends
* three and four point saddle bends
* parallel bends
* segment bends
* concentric bends
* gain/take-up and back to back 90 degree bends
* 90 degree bends around a round, square, and rectangular object

Master Bender can bend and calculate most all types of conduit bends used today by electricians.

Master Bender supports 90 popular bending tools. Master Bender supports hand benders, electric bender ie. sidewinder, 555, triple nickel, and hydraulic bending tools. Have a tool that is not supported? No problem! Master Bender can work with any bending tool. Just tell Master Bender the bending radius for your tool and you are ready to bend.

Master Bender computes bends using both feet/inches and metric measurements.

Master Bender makes it easy to bend pipes and conduit raceways regardless of whether you are a seasoned professional, studying to be in the electrical, electronic, engineering, plumbing, pipe fitting professions, or an hobbyist who needs to bend a few pipes.

Master Bender also has a bubble level and a flashlight.